Search results

Thanks. Today after work I welded in the patch piece for the rear part of the l/s inner cowl panel.

Welcome to NYM.

Thanks Stu, here is more. Today it was very hot (low 90's) so not much welding. Today I welded in the patch for the lower rear section of the l/s door post, & the patch on the l/s outer cowl panel where it meets the inner cowl panel by the torque box.

Today I cut out a rusted section of the l/s outer cowl panel. I also made patches for the l/s outer cowl panel, the lower section of the l/s door post, & the rear section of the l/s inner cowl panel.

Thanks Bruce. Well now that I am finished with the floor I have a couple small spots that need attention. At the bottom rear portion of the l/s door post there were some pin holes, so I cut out the affected area. I also had a bad area where the l/s inner side cowl panel is welded to the l/s...

Thanks Gary. Today I did a test fit of the Monte Carlo bar.

Today I spent a couple hours fitting the l/s seat platform & welding it in. Then I bolted the drivers seat back in.

Today I spent a couple hours & finished welding in the l/s long floor pan, & started fitting the l/s seat platform.

Today I started welding in the l/s long floor & got about 1/2 way done when I ran out of welding wire.