Search results

If you just cut the springs by a coil or so you will get what you want. Unless you use heat you will see NO ill effects from doing this. That should cost you no more than a case of beer from you and a 100 dollar bill.

First off you do not want to increase your tire diameter to offset the wheel to fender spacing. This will actually slow your car down quite a bit and effectively change your rear gear ratio. If you do go with 18" wheels try to make sure the tires you buy are close to the stock diameter. If...

If you want to cam the car go with Hitech motorsports. They have produced the best cams thus far for the 2v motor. You can use the stock springs but it is just added insurance to go with an aftermarket setup. Nextek is considered by car the best spring to go with. I really hope you are...

I have the headers on......the wall. I do not have the ability to do that in my parking lot,:(

The guy who had the car before me riveted SHELBY into the hood so I really have not payed much attention to the outside but hopefully this year I can get it painted and a different hood.

Yes he is. Even on Valentines Day! I told him I would bring Chocolate and flowers to set the mood.:D

2000 GT, 4.6L stock motor, T45, N/A, 4.30s, and BFG DRs 275 17s. 13.21@103.66

Sean Hyland WAS good at one point but now he is known for cob jobbing engines and just screwing stuff up. Cledus, Here is a link to installing the cams which is the only part that you are going to be unfamiliar with. http://www.fordmuscle.com/archives/2006/04/2VOrNot2V/index3.php I can get...

Hello, The name is Chris(obviously) and I have a 2000 Mustang GT. It is just your basic bolt on 5 speed car with: UDPs except crank, plenum, O/R x pipe, catback, gears, and SCT. I currently run with MOMsracing in the WNY area. I have run a best to date of 13.21@103.66 and consistently...