Search results

You still have it?

Re: FOR SALE!! Black Deep disk bullit w/Nittos Drag Radial. 13" Cobra Brake kit (used I have 5 lugs, am using my original spindles with 88 lsc mark 7 rotors

Re: FOR SALE!! Black Deep disk bullit w/Nittos Drag Radial. 13" Cobra Brake kit (used I have a 89 fox, will they fit without any modifications?

Re: FOR SALE!! Black Deep disk bullit w/Nittos Drag Radial. 13" Cobra Brake kit (used Are your cobra calipers still available?

cool, I sent you an e-mail to rich86, I have question for you, would you know if your wheels will fit a 91 crown victoria?

Are your wheels still available?

For 87-93, BBK fuel rails. bbk power plus regulator (boost reference). Complete vortech t-Rex inline fuel pump with hoses fittings and relay.holley 255lph forced air intank fuel pump. This set up will handle well over 400 horse power. All items are less than a month old and in perfect condition...

Sorry, sold

Need a sump gas tank for a 89 stang. I can be reached at monitty@yahoo.com

Am selling a svo computer extender for A9L computer mass air flow 89-95. This extender let's you control air/fuel ratio and over ride computer rev limit. Great for supercharge applications or naturally aspirated. Easy to install, goes in between computer wire harness connector and computer if...

give me your e-mail I"ll send them to you

I have for sale GT40 cast iron heads with new trick flow springs and valves. Heads were recently serviced by a machine shop, cleaned, new trick flow springs (good for a high lift) and valve work. heads are slighly ported on the exaust side not sure of the specs but they flow much better than...

thanks guys, I appriciate the help.

just a E cam

ok cool, what about tightening the roller rocker? Do they get torque?

My rockers are 1.6 pedestal (non adjustable) they were used on my gt40 heads

my first time doing heads, am tired of paying for labor. You seem very knowledgeable, I have a quick question for you. When I took off my rockers the exaust rr had shims. Now my question to you am I going to use the shims again on the aluminum heads or not and also should I torque them down if...

that's sounds pretty good, thanks dude! I will take that into consideration

Am using arp bolts for the aluminum edelbrock heads. I guess am going to go with trial and error, I constantly get different answers all the time. I even bought a haynes repair manual and nothing on torque cylinder heads. Never heard of crushing the head gasket but I'll keep that in mind. Heads...

am using 1011 but is there a special bolt pattern sequence when torqueing heads, I heard 3 steps and 4 steps, 30, 45, 80 or 20, 40, 60, 80 am just ****ing confuse