V2 from draw through to through?

[Noterminator]

What all will I need to do this? Right now I have a draw through setup, but I wanna run a blow through setup with the Procharger race valve. So besides the bypass valve, and a new maf sensor (I'm going with the SCT BA 5000), what else will I need? 2 pieces of piping? I'm new to all of this, so picture illustrations would also be great. Thanks.

 

[blownblu03]

Just need to pick a good place to relocate the meter too on the positive side of the blower. Make sure the meter inlet is a min of 6" after any sort of a bend and the the meter element is on the towards the outside of last bent before the meter to assure the min amount of air bypasses the meter. Also make sure the pop off valve is placed BEFORE the meter meaning closer to the blower and again at least 6-8" before the meter to avoid turbulence.