suspension issues

danielson631

danielson631

Well-Known Member
#1
#1
just installed a tubular k member, a arms, and mmr coilovers. had a bit of trouble getting them in, now i think something looks terribly wrong.

i havent been to an alignment shop yet, so that needs to be done

but can someone tell me if they think this looks right, or what exactly is wrong? thanks





i think the angle of the control arms looks way off, and almost like the end of the a arm, where the grease fitting is, almost looks bent? :confused:
 
Johnarmymp552

Johnarmymp552

Well-Known Member
#2
#2
The passenger side ball joint does look like it was welded slightly angled upwards, maybe it is just the pic.

Just remember do not fully tighten the a-arms bolts to the k member without the car sitting on the ground.

Make sure the car is on as level ground as possible, adjust coilovers to get the body to sit right where you want it. Sway bar will help keep both a arms complimentary of eachother.

You also need a bumpsteer kit.
 
danielson631

danielson631

Well-Known Member
#3
#3
thanks im going to get out there and try to adjust everything and check it out today. also take more pics to try and explain things better.

is the bumpsteer kit a must?
 
You must log in or register to reply here.