Roll cage install!

[Jays04mach1]

I finally got around to installing the roll cage in my Mach 1. I've been laid up for three months due to rotator cuff surgery. I'm aloud to work again so this was a good way to celebrate.

Heres the interior prior to dissassembly.

Seats and center console are removed

Bye Bye carpet!

Measure,Measure,Measure and Measure again

Left side door bar mount installed

Right side door bar mount installed

Rear panels with the holes drilled. I bought the panels with the cage to save my stock ones

 

[04 orange cobra]

LOOKING GOOD.. Where did you get this and who makes it ??? Is the cage removable ??

 

[Jays04mach1]

More pics


6 x 6 plates in the rear wheel wells.

Drivers door bar installed

Passenger door bar

Finished product!





I bought the carpet with the holes cut too. Just in case I wanna return this car to stock my original carpet is still intact

A special thanks to Roy from Mach 1 registry for the cage, panels and carpet. Thanks to Hudson Valley Powdercoating for a great job on the cage.

 

[Jays04mach1]

LOOKING GOOD.. Where did you get this and who makes it ??? Is the cage removable ??

The cage is fully bolted in. NHRA certified for 9.90's, if I recall correctly. Roy from Mach 1 registry did the cage. He had it in his Mach 1 and sold me all of the goodies when he went to a full weld in 12 point. Door bars are removable if I want to. I'll be at the show on Sunday if you want to check it out. I just have to buy some stainless hardware for the door bars and rear tubes. The Yellow Zinc grade 8 stuff i have now looks kinda crappy.