new power/tq numbers

Status
Not open for further replies.
B

Blwn04

Well-Known Member
#1
#1
Sorry i have been MIA, only get on here once and a while...any how....after all was said and done last week at Mustang Magic my car made 616hp & 562tq @ 17psi (3.0" pulley) this was de-boosted from my 2.8" street tune for safety and motor life....but then we cranked it up 2.6" pulley made 644hp/606 tq @ 21psi w/104 octane.....thing is a rocket...i will have some et/mph numbers this coming monday when we have our rental at atco...wish me luck...looking for mid 10's @ 130+mph....i ordered level 5 axles but UPS screwed me by damaging one of the 2 boxes shipping label's and delaying my delivery...so im praying the et streets help my axles live thru a day of racing....i have a trailer just incase.

 
Last edited:
B

Blwn04

Well-Known Member
#4
#4
04 orange cobra said:
DAMN.... Any dyno video... :D Which level 5's ???
Click to expand...
The ones with the porsche inners and outters....bad boys...im going to lebanon valley on may 27th too so ill put them to use.

my buddy Zee has vids ill try and get them.

Oh and i failed to mention im adding 1 more psi to the car on race gas.....gotta love the xcal 3 and having a wideband....should be making over 650/620 on monday
 
B

Blwn04

Well-Known Member
#6
#6
BKD said:
2.6" pulley made 644hp/606 tq @ 21psi

damm very nice :awesomework: thats alot of boost ..
Click to expand...
22psi with the 2.5" pulley thats going on it monday...2.6" was borrowed from a buddy....and out of stock so i had to go with the 2.5" should be 22psi if theres no belt slip issues...and about 650+ hp & 615+ tq......i dont run a lower pulley due to bad stories of twinscrews and crank issues,....so im stuck going smaller uppers for boost, this is the smallest i can go, the whipple is tapped out anyways pretty much.
 
meanlx

meanlx

Well-Known Member
#10
#10
Very nice #s my man......congrats! :headbang: Also, I just checked SVTSnake and I think I'm the winner of the $50 prize. Winning......duh! :D

ULL_LOSE said:
i hope your rear end holds up on those numbers...

what will you be launching at?
Click to expand...
:imwithstupid: Good luck with that Jay. lol
 
Last edited:
Timspony

Timspony

Capital District Coordinator / Super Moderator
NYM Staff
#13
#13
Slicks or ET Streets actually safer for the Stock IRS half shafts...as they will absorb the Cobra Power!!! :)
 
0

03SONIC

Member Plus
#17
#17
That is STD so SAE its about 580 or so, that is the norm for these blowers. I would forget chasing dyno numbers and get it down the track, with a good 60foot and shifting good the car should get into the 10's in street trim.
 
Status
Not open for further replies.