Installing Accufab TB and Plenum

[stringtheory]

Can anyone who has installed one of these give me any tips regarding installation problems, gasket requirements, etc? Which Cold Air Kit did you install with it? appreciate any and all feedback.

 

[04 orange cobra]

I installed the big oval TB and bigger plenium on mine and it came with the gaskets.... running a K & N filter with C & L inlet.... very easy install....

 

[MineralGray02K]

Mine also came with the gaskets. When I was n/a I went with a C&L Tru-flow pipe w/ K&N filter.

What size TB and plemum did you go with?

 

[stringtheory]

I went with the 70 mm TB as the car is only mildly upgraded. It only came with one gasket; apparently the one that goes on the side of the plenum. Should there have been a new gasket where the plenum sits on the manifold? The TB and Plenum were ordered as a NIB unit from American Muscle.

 

[modularmustang]

i got the 70mm accufab TB too, its all you'll need with an N/A setup. As for install, very straight forward. Only thing that was a pain was getting the stock hose over the TB, as its a bit bigger and the intake hose doesn't like to stretch.

the gasket that is on the intake manifold to plenum is reusable, its rubber, pull it out and clean it and then put it back it.