I lost my headlights and swaped out the headlight switch and that did not work. So I ordered the multifunction switch for the wipers/ highbeams , becasue when i clicked it the lights would come off and on now they are doing nothing. When I removed the switch to replace it I noticed the factory clip p is damaged.. what can i do to fix this and get to some lights? Se the attached photo. the top of the bottom right wiring harned is broken and burnt out. Which harnes is this and how can i replace it? should that fix the issue?
Head light Help / MultiFunction switch
- Thread starter KazenNYC
- Start date
Typical for these cars..... You can ditch that connector and get good wire connection insulators , and just wire each wire individualy to the pins. Basically it's a custom wiring job, or you might get the wire section from a junkyard, but it will melt again eventually. Hit the parts store and go electrical shopping. Good luck.