Just ordered a set of Cushman stage 3 blower cams and trickflow spring set! I can't wait to install these cams next weekend. I hope it doesn't put my motor over the top with HP and blow my motor though lol
I will post pics along with a video of the finished install next weekend!
Will do! I am putting my car on a dyno tomorrow to see what the real HP numbers are since you know when you buy a car from someone they always exaggerate the HP numbers lol
It's a mustang dyno so it will read low but I just wanna get an idea so I don't go over with the motor and blow it.
Yes, Yes I do. I got the car dyno'd today and she is only pushing 375 rwhp and 390tq so the blower cams will give me a nice gain and put me right to about the limit.
oh ok i just wanted to make sure. i know when i was looking around it seemed about half of the cams wouldnt fit with stock pistons. good luck ill be looking forward for the vid and dyno numbers since our numbers are about the same.
Finalllllllllly got my CMS stage 3 blower cams in but still no spring set! grrrrr....Hopefully they are close behind and will be here this week so I can install this weekend
Well I am at a standstill, the POS valve spring compressor is the worst tool ever designed and made. Maybe tomorrow I can find a better one but if not it won't be done until mid week or next weekend :-(
Finally got all the springs changed. I didn't work on her all week cause of work and I was waiting on a new valve spring compressor that worked AMAZING. I changed 10 springs within 2 1/2 hours.
Tomorrow I can finally start putting it back together
