bolt ons

[j93mustang13]

DAMNNNNN IMMMMM GOOOODDDDD !!!!!

YouTube - ‪DAMN I'M GOOD!‬‏

YouTube - ‪Ace Ventura - YES!‬‏

 

[j93mustang13]

im at wwork now but tomorrow im gunna check the heads. should i get more then 24lb injectors? i was also thinking roller rockers. my exhaust is mac unequal length headers to a race cat to xpipe to unknown mufflers to dumps. i was gunna jus get bbk headers and go straght pipe to the side

 

[dsblk93gt]

The limiting factor is the stock block, I had a 331 stroker and sold it and stuck a stock 90 shorblock in my car. It will take just as much power, it just won't make as much NA and takes a little more boost than the stock one. The DSS motors are a little over-hyped, not saying they are bad but it is still a STOCK BLOCK.

 

[dsblk93gt]

GT40 heads say GT on the corners and the GT40P say GTP. GT40 have 3 "bars" on the front of them and the GT40P have 4.

Like Bone said the aluminum heads are pretty easy to identify. Take pics and post them up if needed!

also note the "GT" in corners for the GT40

GT40P "GTP" in corners like I said above and 4 bars on the front of them.

Also have GT40P in the head.

 

[dsblk93gt]

Could also have Windsor Jr or Sr heads or Roush cast iron. Hard telling.

 

[jkstang78]

Most Companys stamp the front and back of the heads. You can see where it is stamp on My heads. You might have to pull the Alt and alt bracket off to see