Selling my headers and mufflers out of my 68 Mustang.
Details
The motor was a 302 block with AFR 205's. The headers have 1 5/8 stepped to 1 7/8 tubes with 3 inch collectors. I have EGT bungs welded in each tube with pan evac and O2 sensor bungs in the collectors. These were built by ABS Chassis. The coating was done by Jet Hot. My car oringinally had a power rack but I used a power to manual conversion.
I am also selling the mufflers that were on the car. The mufflers are Spintech 3 inch oval. They are not very long but you could cut the trasitions off and weld on new ones to make them longer. I have ground down all the welds and also had them coated by Jet Hot. As you can see the have turn outs on them.
Headers I would like to get $800. Thats well under half what I have into them!
Mufflers I would like to get $200 out of them.
I will take offers just don't be stupid I don't mind putting them in my shed if I can't get around what I want out of them!
Details
The motor was a 302 block with AFR 205's. The headers have 1 5/8 stepped to 1 7/8 tubes with 3 inch collectors. I have EGT bungs welded in each tube with pan evac and O2 sensor bungs in the collectors. These were built by ABS Chassis. The coating was done by Jet Hot. My car oringinally had a power rack but I used a power to manual conversion.
I am also selling the mufflers that were on the car. The mufflers are Spintech 3 inch oval. They are not very long but you could cut the trasitions off and weld on new ones to make them longer. I have ground down all the welds and also had them coated by Jet Hot. As you can see the have turn outs on them.
Headers I would like to get $800. Thats well under half what I have into them!
Mufflers I would like to get $200 out of them.
I will take offers just don't be stupid I don't mind putting them in my shed if I can't get around what I want out of them!
Attachments
Last edited:
