[ame="http://s1128.photobucket.com/user/FiveOh86LX/media/16SVOsideview_zps111a8aa8.jpg.html"]16SVOsideview_zps111a8aa8.jpg Photo by FiveOh86LX | Photobucket[/ame]
[ame="http://s1128.photobucket.com/user/FiveOh86LX/media/16SVOtopview_zps980ec82f.jpg.html"]16SVOtopview_zps980ec82f.jpg Photo by FiveOh86LX | Photobucket[/ame]
I'm trying to install 1.6 SVO RR pedestal mount w/ a bolt not stud.
Have a few questions about, do they look right? I mean there is the small guide plate on the bottom, with the pedestals on the top of it, and the rockers just sit on them correct?
Is there anything to keep them from sliding sideways (left/right, horizontally)?
Is it just really this bolt holding them down and thats normal? I've always seen studs.
I'm assuming these would be to be retightened every now and again then?
My stock valve covers do not fit on it just setting them on there... Will a cork gasket lift it enough to make it fit?
-If I buy tall valve covers then I need to find a intake spacer, and I cannot find a proper intake spacer for an edelbrock RPM upper+lower intake...
Lastly, I'm setting them to zero lash at the round part of the cam lobe, then tighten to 20 ft/lbs, and shim if necessary?
[ame="http://s1128.photobucket.com/user/FiveOh86LX/media/16SVOtopview_zps980ec82f.jpg.html"]16SVOtopview_zps980ec82f.jpg Photo by FiveOh86LX | Photobucket[/ame]
I'm trying to install 1.6 SVO RR pedestal mount w/ a bolt not stud.
Have a few questions about, do they look right? I mean there is the small guide plate on the bottom, with the pedestals on the top of it, and the rockers just sit on them correct?
Is there anything to keep them from sliding sideways (left/right, horizontally)?
Is it just really this bolt holding them down and thats normal? I've always seen studs.
I'm assuming these would be to be retightened every now and again then?
My stock valve covers do not fit on it just setting them on there... Will a cork gasket lift it enough to make it fit?
-If I buy tall valve covers then I need to find a intake spacer, and I cannot find a proper intake spacer for an edelbrock RPM upper+lower intake...
Lastly, I'm setting them to zero lash at the round part of the cam lobe, then tighten to 20 ft/lbs, and shim if necessary?
Last edited:
