Search results

Installed a Tanks inc fuel pump in stock tank and ran 3/8th stainless tubing for supply and used original supply for return

FP is at 39lbs New 02 sensors Hooked up,new harness Engine to body ground strap ( maybe i should run a seperate ground from the computer case) Holds good at 2000 Mass air meter is clean IAC not functioning, Have power to red supply wire but no signal from comp on white/blue wire

My intentions were to get everything up and running good and then slowly start to upgrade for performance. when i started it up this morning the idle surged up and down and close to stalling, i disconnected the IAC and there was no change. so i replaced it but still no change. It seems like it...

Timming is at 12deg Stock 55mm TB Stock Regulator Only codes are the ones associated with removal of the EGR and EVAP systems

I did the 90' gt conversion into my 68' runs great but the idle is erratic and running rich (burns the eyes. Motor is a stock rebuild with a B303 cam, Stock fuel injection 9AL comp,All new sensors and 19lb injectors. It looks like i goto get the computer tuned. Any good recommendations on the...

PM'ed both of you

I need a wire harness section for my FI install in my 68'. The section i need is for the 02 sensors to the main harness. the 5.0 engine, fuel injection and harness are from a 90'GT. Also need the 5.0 HO intake manifold plaque. Please help a fellow Stanger :D

Thanks i will try them

Currently giving the FI treatment to the 5.0 in my 68' but i need some advice. 1. When removing the EGR and installing a block off plate are the 2 small coolant hoses nessesary( i am not useing the 5.0 heater hose tubes) 2. How to test an A9L computer 3. Source for 02 sensor harness ( its the...

Do you have the section from the main harness to the O2 sensors?

yes, mechanical,still on car

Also have an Edelbrock Performer intake have Dizzy with Petronics Electronic conversion, Flame thrower coil. i can send pics. weiand manifold and carb is on car rar right now. can you send pics of what you got?. Where are you located?

I am looking to covert from carb to FI. Got Wiend intake,edelbrock carb, fuel pump ect.

Do you have a 9Al computer and Standard trans harness?

They have the Corn feed in Iowa and a mini Corn feed in PA. As far as All fords at Carlisle, I havent missed it in 20 years. I usually dont bring the stang because we are either selling or buying something big. I also attend Spring Carlisle.

PM me about this mini meet, I tried to make the one in PA but it was a bad date.

Yea Mike i have been haunting the VMF for about 8 years now. I think this club will give me a good opportunity to meet and interact with Mustangers old and new and local. The VMF allways seemed to lack members from the NorthEast but an awsome site.I am thinking about doing a few more shows...

test

Got the pics, just got to figure out how to post them

I did the M2 heidts about 5 years ago and is with no doubt the best modification i ever made. I spent lots of money on expensive aftermarket components to keep it somwhat stock but never got it to handle like i wanted it to and that disaster Ford called power steering needed to go. I did not...