Search results

Up for sale is a ford 7.5" rear axle assembly pulled off a 2001 Mustang V6. Good for someone looking to put a posi/gears in it. It will work as is but will need new carrier bearings. I will accept any reasonable offer. thanks Marco

i want to get an aluminum driveshaft, but can't find one listed for my (2001 v6) vehicle. Is it the same driveshaft as the one found in a similar year gt?

I'm planning on swapping from original 7.5 to an 8.8. Is my original driveshaft going to directly bolt on and work properly with the 8.8? thanks

I used to have the same problem on my 01 v6. I found that the MAF sensor gets dirty and causes this issue, especially due to oil coming off my K/N filter. Here is what i have to do once a year to keep it under control. 1. disconnect your negative battery terminal. 2. buy a can of...

sra, unless the irs is a direct bolt-on to a 2001 v6 thanks

looking for a complete axle assembly for a 99-04 8.8" please email massimi.marco@gmail.com

i checked the driveshaft. The weights seem to be all there. I jacked the rear end up again, ran it to 70mph and watched the driveshaft as it turned. I found a vibration at the front end where it meets the tranny output shaft. The tranny is also leaking fluid from the top for some reason. I...

the driveshaft has never been removed. I've heard of driveshafts being unbalanced...if that were the case my car would have had the vibration since new, unless the unbalance condition somehow developed over time. i want to have it checked for unbalanced driveshaft and bent axle shafts/axle...

could abusive driving(dumping clutch, burnouts, etc.) warp the axles? im sure warped axles would cause huge vibration

the axles seem to be true to the naked eye but im no expert. My main suspects are the driveshaft being out of balance, but im convinced its the wheel bearings that are worn out and causing freeplay...I removed the brake assembly and i could push the spindle in and out and move it a little side...

i have a 2001 v6, and i've had a rear end vibration as soon as i go past 65mph. this has been going on for a couple years now and i thought it was a wheel/tire out of balance condition. I just got new wheels, which takes that out of the equation. I still have the rear end vibration. today i...

sorry i can't read i thought you meant 1 1/2

how much do u want for them

i think 1 1/4 should be good for me

looking for 5 lug spacers for a 2001 mustang for the rear wheels. Please email me at massimi.marco@gmail.com thanks Marco