Search results

[borat voice] VERY NICE!!!!!!!

Sounds cool! How far is it from Albany?

I may go down on Sat May 1st if anyone will be there we should get together for lunchor something..

Where you headed Tim?

I'm saying, the tight spot that may need to be drilled is not visable?

LMAO!!! Hahahahaha That's great

Wow, that's a quick car!

Holy chit mang, that's b'dass

Where you located?

Wow, that's sweet!!

The problem area (that needs to be drilled out) is not visable from the outside at all?

is there a way to notch the pilar inside to make it work for the -4an line?

very nice, thanks for the help!! I appreciate it very much! I need to get in there when I do the springs so I think I am going to do it all at once!! Shouldnt be an issue to use -4an steel braided line right? Thanks again Tim!

very nice. i will check it out and see if I can spot it. How did you run the line into the car from the engine bay? Thanks for the help Tim!

I was going to use the nylon line while installing my gauges, then I was going to use a copper line and I did some research and the angle in the pod isn't a good idea for copper line so I decided to run steel braided line with crimped ends. Can someone please tell me where I tap for the oil...

Well I'm done working in Amsterdam, heading home to eat dinner than working to replace the injector in my truck. If I'm done in time I will be taking the stang for a cruise!

I have a lot going on tonight.. Wish me luck getting the truck back on its game 110%!!!

I'm going to start working on the truck at like 6-7 so I donno if I will be done by then... If I'm done and its set I will be there if not Ill see you all next time!!

I drove by on my way home from Target and saw the red viper, yellow vette, some RX7 and a honda.... :(

very nice pics man!!