Recent content by Bullitt520

How much for the catback?

Are the heads in good working order? What kind of power did you make with that H/C setup? Were the heads ever ported??

I live 15 minutes away so Ill be there every week. Probably wont have the Mustang down until June though. When I do Ill start coming across the river to meet up. If it rains as much as it did last year on Wednesdays I'll kill someone. It seemed like the show was held only once a month.

Hey I'm looking to buy a set of ported E7 heads. Bare ported is fine too. Let me know what you got. Thanks, Colin

Ill be there.... Not with my car but I do go to Manhattan College so what the hell Im in.

And the fuse blows not when I try to turn the power on to the, but right when i connect the wire to the source.

Yes i had to wire the fan from scratch. I believe it is a ten or twelve gauge wire going to the relay as it. Like I said, the fan works for sure I just bought it without and wiring or anything.

Also could someone try to explain what I should to to diagnose the ignition switch problem?

So what should I do to correct the short? Would I be able to find the brackets anywhere or be able to make them?

What is the highest amperage relay you have? I think I may need a higher amperage relay than 30 to run my taurus e fan.

Thanks alot. I will use my test light to find that where to wire the accesories. I dont understand what you mean by neutral safety switch. Where is it and how do i check it? As far as the fan goes it is a taurus electric fan and it has worked with power directly to it. It has been blowing...

Hey guys I've been at college the past couple months so I don't get much time to work on the fox. Regardless, the problems I was having this summer are even harder to figure out when I'm here and not able to work on the car. So I was wondering if you guys could help me with a few problems so...

Pictures of the Flows??

Are the flows just the mufflers or will they connect to a 2.5'' h pipe flange?

THe ports on my headers are square. Is it possible that they will be compatible? Theyre mac equal lengths. I would like to keep shorties to avoid also changing my h pipe.