Swapping mufflers.... to just resonators??

[FiveOh 86LX]

I'm sure many people will give me flack for thinking of this but I'm used to dumps on my mustang lol...
I have full BBK exhaust 2.5" with ceramic headers, HI FLO cats, and super turbo mufflers... It is pretty quiet...... My muffler is literally half of an inch or less from touching my aluminum driveshaft... due to size, and sound... I am thinking of replacing my mufflers with SLP resonators...
Anyone have input on such an idea

 

[Noterminator]

Most will say SLP's are just noise or loud. Which they are, but its still a sound lol. Its your motor screaming with no disturbance lol. Anyway I had SLP loudmouth axle backs on my 2011 GT and loved them. They screamed when needed lol.

 

[FiveOh 86LX]

I just don't want it to sound too raspy, or "straight pipey". The Cat's quiet it down a lot I hear

 

[the5.ohh]

Look into Dynomax race bullets if your going wit straight through. they actually have tone to em and give a nice deep rumble. Sound better than SLPs imo. SLPs cost like $150 for just two "resonators". Dynomax race bullets are about $45 a piece

 

[FiveOh 86LX]

Welding these diagonally is the usual action to take when going straight throughs?

 

[the5.ohh]

Just like normal muffs I'd think.

 

[FiveOh 86LX]

My normal mufflers are offset, as in goes in the muffler closest to the driveshaft, and then comes out farthest from the driveshaft, I don't think they would just 'weld' or 'clamp' right in place due to that?
Could be wrong though!

 

[the5.ohh]

Ooo i gotcha lol. Um an exhaust shop would have to mess with the piping but thats pretty much it