Wideband gauge and Tach install

02S281

02S281

Well-Known Member
#1
#1
Has anyone here installed a wideband a/f gauge and a tach? Diagrams such from autometer i think so i was wondering if anyone has done it and/or has a write up on doing it.

Thank you
 
MaximumRisk

MaximumRisk

NYC Regional Coordinator
#2
#2
I have never done a tach on a modular motor, so can't help you much more than what you probably already know, but I installed a wideband on my car (innovate) and it was very straight forward. Do not have a write up though, but is there anything in particular that you would like to know or need help with?
 
02S281

02S281

Well-Known Member
#3
#3
Is it pretty easy? Where do you put the o2 sensor if you have long tubes and a o/r x pipe. Would it just go where one of the front o2's go?
 
9

97modgt

Well-Known Member
#6
#6
Just blow a hole in one of the banks.weld the flange in there. Mount that sucker at a 45 degree for best results and do not install it in the x pipe where the pipes meet. If you only have a single o2 and you are concerned about a/f at each back, just swap it over during tuning. your tuner should be running his own wideband but you could always use yours in one bank and the tuners in the other. I have never installed a tach but that would be interesting to know. shout out if you see a website that pertains to a tach install if you decide to research a bit. good luck with the install.
 
Last edited:
You must log in or register to reply here.