Upper and lower intake install...

BKD

BKD

Well-Known Member
#1
#1
Is there any good links or sites to get step by step install instructions for upper and lower intake ...gt 40 ?

Thanks
 
PrjctLxEnvy

PrjctLxEnvy

Rockland County Coordinator
#5
#5
sorta.... its not the GT40 Gregg but it is the same general idea.. i would assume if you go on summit and click the FRRP GT40 upper n lower to purchase you can go to the adobe accobat reader and it might give you a full set of instructions to download.
 
BKD

BKD

Well-Known Member
#7
#7
>Its a very straightforward install.

YEA BUT IM JUST WONDERING IF SHOULD USE ANT SEIZ OR LOCK TIGHT ON SOME BOLTS OR ANYTHING THAT I SHOULD SHOULD NOT DO......

IM ALMOST READY AND I JUST WHAT TO DO IT ONCE ..AND DONT WHAT TO MESS IT UP....

>There should be mulitple PDF's available for step by step instructions

WHAT IS PDF's ......? THANKS
 
BKD

BKD

Well-Known Member
#10
#10
One more ?......i got the gasket set and im not sure if i should use the front and back lower gasket to the block or just use gasket sealer...?

Hummmmm......
 
T

TERROR

Well-Known Member
#12
#12
just use gasket sealer instead of the gaskets. i usually never use anything on the intake bolts but check them after a few days of driving the car
 
MaximumRisk

MaximumRisk

NYC Regional Coordinator
#14
#14
Actually, I would recommend anti-seize on every bolt that goes into the lower intake manifold especially the ones for the thermostat housing
 
BKD

BKD

Well-Known Member
#15
#15
>
Actually, I would recommend anti-seize on every bolt that goes into the lower intake manifold especially the ones for the thermostat housing


NOT A BAD IDEA...THANKS
 
You must log in or register to reply here.