Well this weekend I installed a Roush spoiler on my 2013 Mustang. Be careful removing the old spoiler. I started at one end and worked my way down to the other end. When you are lifting it up it can scratch the paint at the far end. The new spoiler covers it, but still be careful.
Drilling the holes is a little daunting, but be patient. I decided to make the end plates centered to the trunk opening. I had to file the holes bigger so it sat flat on the car, then I aligned the center spoiler to both ends.
One note I had trouble where to place the 2X tape on the center spoiler, but if you look carefully you will see they have channels all set for the tape. Another issue is the torque is in inch-pounds, NOT foot-pounds. All in all it looks good. Reminds me of my 1991 300zx twin turbo spoiler.
Drilling the holes is a little daunting, but be patient. I decided to make the end plates centered to the trunk opening. I had to file the holes bigger so it sat flat on the car, then I aligned the center spoiler to both ends.
One note I had trouble where to place the 2X tape on the center spoiler, but if you look carefully you will see they have channels all set for the tape. Another issue is the torque is in inch-pounds, NOT foot-pounds. All in all it looks good. Reminds me of my 1991 300zx twin turbo spoiler.